Don't risk downtime waiting for a replacement parts!
To keep your machine running also when you had a little accident.
Spare parts kit specifically for your Super 1050 machine.
CM-2001 Case/Media Separator is large, 25,4 x 35,5 cm and will hold more than 1,600 .38 Special cases. It sits on a large media collection tub that measures 45,7 x 55,9 cm. The tub keeps the mess off the floor and bench. It's fast -- so fast it will remove media from 1500 rounds of .223 brass in a matter of seconds.
The CM-500 Case/Media Separator is scaled down in size and designed to handle the load of a CV-500 Case Cleaner. This piece of equipment are every bit as tough as its full-sized counterpart. We used the same materials in its construction and designed it to work just as hard -- and do it in a more compact area!
Small Pistol .32, .380, 9mm, .38 Super, .30 Carbine
Large Pistol .40 S&W, 10 mm, .38 Special and larger, 7.62 x 39
Small Rifle .204 Ruger, .222, .223 Remington
Large Rifle .22-250 and larger
Spare parts kit specifically for your XL650 machine.
Caliber conversion is not included.
Super 1050 Quick Change Kits allows you to leave your dies and powder charge set up and dedicated to a specific cartridge for faster, easier caliber changes. Caliber changes require a caliber conversion kit (sold separately) in the caliber you want to add to your Dillon Super 1050.
This set consists of one Super 1050 powder measure nr. 20421 and one Super 1050 Toolhead nr. 20420.
Be aware that the ratchet does not interchange between the Super 1050 and the RL1050 due to differences in length. If you have an RL1050, order toolhead #19399.
Dillon Precision Primer Magazine Tube Small SD / RL550/ Super 1050
Dillon's CV-2001 Vibratory Case Cleaner is the largest in the industry. Its 12-1/2 quart bowl capacity will allow you to polish up to 1,300 .38/.357 or 550 .30-06 cases per hour.
Not only is our capacity greater, but our motor is larger in horse power, internally cooled, thermally protected, and turns on precision ball bearings. This is no "hobby" machine!
The bowl and base are constructed of 7/32" thick injection molded high-strength polypropylene which is impact and abrasion resistant.
Note: Tumblers are not designed for tumbling loaded ammunition.
This mount is for both the RL 550 series presses as well as the XL650. Mount height = 8 1/2" or 21,6 centimeters.
Raises your press above the work bench level and adds stability due to its larger footprint.
Recommended by lots of reloaders.