Select your country here
Please select your country
Panier vide
3GUN
with M-LOK HANDGUARD in H152 Stainless Cerakote
CALIBRE : 223
LENGHT : 18” – 20”
TWIST RATE : 1/9
UPPER: Forged and machined from our design billet – AL7075T6
Hard black anodized
MIL-SPEC and M4 Feed ramps
Charging handle with tactical latch Ambi Oversize
Made stronger than other similar commercial rifles
LOWER: Forged and machined from our design billet – AL7075T6
Enhanced flared/Magwell magazine
Integral trigger guard
Mag. release OVS
Bolt catch OVS
Selector Ambi 45°
BARREL: Lothar Walther – 3GUN profile – thread: 1/2×28 with Sport compensator
GAS SYSTEM: Direct gas impingement with gas block low profile adjustable
BOLT CARRIER GROUP: Stainless Stell – Lightweight with QPQ Treatment Antifriction – Black
HANDGUARD: CNC machined, free floated Ventilated, M-LOK H152 Stainless Cerakote
Possibility to regulate the gas block from outside without remove the handguard
TRIGGER: MIL SPEC with lightweight springs
STOCK: Fixed competition
Polykrepp gun cloths, for cleaning, lubricating and wiping off excess oils.
Glock Factory Connector
Install the 4 pound connector! A standard Glock has 5,5 pound triggerpull !!
This part replaces the factory connector and provides a lighter trigger pull. This will increase the accuracy of most shooters by reducing the amount of muzzle movement when pulling the trigger.
Your trigger pull will be 4 lbs when you keep the 6 lbs factory firing pin spring, but if you Change that one out for a competition firing pin spring of 4 lbs you will get the 3,5 lbs trigger.
Less experienced shooters should ask a gunsmith to install this item.