Dillon 1050 and 1100

Stop switch enables you to lock the case feed shuttle back to prevent cases from feeding into the shell plate when cycling the press. Easy installation. Just screw with two original bolts. Built in hinge made for super easy usage, cycle machine to down position and enable stop switch. Built in bulge that locks switch in case ON position.  Great for clearing the shell plate, maintenance, setup, or any time you don’t want cases to feed.  Made from high quality steel. This product is suitable for Dillon 1050 only.

This is a Debris Catcher for Casefeeder. The Dillon Casefeeder has two holes in the bottom back of the bowl assembly. These holes allow any accumulated spent powder, polishing media or general crud to drain out of the bowl. This debris if left unchecked can fall all over your press or bench top.

Tired of emptying your spent primer cup or knocking it over spilling spent primers everywhere?

Install Armanov Spent Primer Chute and forget about It. Zero mods to reloading press required, it re-uses the original screw to install and installs in place of stock spent primer cup bracket.

Powder measure knob for the Dillon Powder thrower with click for easy adjustment. Unlike other competitors, this knob is laser etched with 50 graduations giving the user reference points when adjusting. Two steel spring loaded balls generate smooth and repetable clicks. Easy to setup between multiple loads or even calibres, very precise 50 clicks per turn. 

This toolhead for Dillon Super 1050/RL1100 is a real game-changer. It is a drop-in upgrade for the original toolhead with great new features.

Bushings are made for a quick, simple and precise change of dies in the toolhead. No need for a complete toolhead change anymore, just twist and replace any bushing with the die of your choice. Change six dies on a Dillon Super 1050 / RL 1100 in seconds!

Armanov Quick Disconnect replaces original Dillon Powder Measure half-ring retention.

Designed for economy of motion when loading. Our new bullet tray is made of durable cast aluminum and is powder coated Dillon Blue. Fits RL 1050 / Super 1050.

As any reloader knows, adjusting a die on a tightly spaced tool head can be difficult and aggravating. The die nuts and various machine parts do not allow easy access and using regular wrenches can be near impossible. The DAA 1 Inch Box-End Wrench is the solution to this problem! The custom made, laser cut, stainless steel wrench is strong enough to last a lifetime and thin-walled enough to fit between any dies for easy access and adjustment.

The DAA Infra-Red Low Powder Sensor is an efficient, high-tech solution to a problem every reloader has encountered: Making sure to fill that powder hopper in time, before you accidently load empty cases without powder… (don’t feel stupid, we’ve all done it…)

The DAA Powder-Spill-Prevention (PSP) Brush is a simple yet efficient reloading accessory that solves a real issue: How to prevent small amounts of powder being spilled out of the case, as the tool head of the progressive reloading press indexes?

This bin is 260mm long, 110mm wide by 120mm deep and is great for storing just about anything.

This enhanced heat-treated toolhead washer and hex key bolt reduces any flexing of your toolhead, increasing the rigidity and potentially the consistency of your ammunition. This works on the RL1050 and Super 1050 as well as the RL1100 loader. Requires a 1/2" hew key wrench to install and remove the bolt.