Accesories

Install by slipping this on the top back side of your case feeder and fits to the Dillon Case feeder 550 / 650 / 750 / 1050 / 1100 or Hornady LNL AP Bullet / Case feeder support tubes.

Powder Funnel for activating the Dillon automatic powder system. An essential component for reloading 9 mm family of calibers with any bullet-feeder system with your Dillon powder measure. It prepares the brass correctly so that the bullet can be seated in the case, and not tip over as you index the shell plate.

If primer does not explode when hit by firing pin then most common reason is that primer is not seated deep enough. This problem is quite common in new XL750 since orginal primer punch spring is a little to long and primers are not seated deep enough. Armanov solution to this problem is new Index Cam Block with integrated ball bearing and adjustable primer seating depth stop.

This enhanced heat-treated toolhead washer and hex key bolt reduces any flexing of your toolhead, increasing the rigidity and potentially the consistency of your ammunition. This works on the RL1050 and Super 1050 as well as the RL1100 loader. Requires a 1/2" hew key wrench to install and remove the bolt.

The DAA Infra-Red Low Powder Sensor is an efficient, high-tech solution to a problem every reloader has encountered: Making sure to fill that powder hopper in time, before you accidently load empty cases without powder… (don’t feel stupid, we’ve all done it…)