Reloading equipment

If primer does not explode when hit by firing pin then most common reason is that primer is not seated deep enough. This problem is quite common in new XL750 since orginal primer punch spring is a little to long and primers are not seated deep enough. Armanov solution to this problem is new Index Cam Block with integrated ball bearing and adjustable primer seating depth stop.

This enhanced heat-treated toolhead washer and hex key bolt reduces any flexing of your toolhead, increasing the rigidity and potentially the consistency of your ammunition. This works on the RL1050 and Super 1050 as well as the RL1100 loader. Requires a 1/2" hew key wrench to install and remove the bolt.

The DAA Infra-Red Low Powder Sensor is an efficient, high-tech solution to a problem every reloader has encountered: Making sure to fill that powder hopper in time, before you accidently load empty cases without powder… (don’t feel stupid, we’ve all done it…)

Since we introduced our DAA Turbo Case-Feeder Plate for the Dillon case feeders, we’ve had Mark-7 customers asking us if they could use it with their High Speed 11” Mark7 case feeder (as supplied with the Apex-10 press). The answer is YES! The disk is the same size and it works great in the excellent Mark-7 case feeder. 

The DAA Primer Pickup Tubes are made of the highest quality aluminum, produced using custom-made extrusion tools and tightly controlled for accuracy and finish. Close attention is paid to the consistency of the internal and external chamfering to ensure optimal feeding. The matt-finish anodizing makes identifying the primer size immediate, while giving these tubes a striking attractive look.

Primer Stop Block for Dillon Precision XL750 Progressive Reloading Press. Comes very useful for operations when no primer insertion is required. The block prevents movement of the primer slide bar. Super simple installation by simply inserting the block between the pin on the slide and primer feed body. When not in use attach it to the steel primer tube by the magnet

Bushings are made for a quick, simple and precise change of dies in the toolhead. No need for a complete toolhead change anymore, just twist and replace any bushing with the die of your choice. Change six dies on a Dillon Super 1050 / RL 1100 in seconds!

Kit contains QTY 5 of 301-1178 Shell plate springs 0.094" Dia, 0.018" Wire Dia, 302 SS cut to approximate length.

Also contains QTY 2 1" sections of 201-1210 Case Retention Spring 0.125" OD, 0.02" Wire Dia

This toolhead is required for use with RT1500 Electric Case Trimmer. This combination is commonly used to trim 300 AAC Blackout on the XL650 & XL750.